Re-Usable Stencil Instructions.

 

• First of all, make sure that the surface you are painting is clean, dry, and free of any loose debris. (any loose debris will become a messy part of your stencil on the tacky side)
• Slowly peel the stencil from the backing. (The temperature should be between 50-80 degrees F. for optimal results) Colder temperatures make the stencil material difficult to remove and easily damaged.
• Affix the stencil to the surface you are painting and ensure that even pressure is applied to the entire surface. Pay particular attention to the lettering to make sure that it is completely attached to the surface so you don’t get any paint bleeding or overspray.
• Apply at least two coats of paint, more if desired to make sure that you get a bold contrast.
• Peel the stencil slowly from the surface ONLY when the paint is completely dry!
• When done, simply put the stencil back on the backing and save it for use later!
• A little about the material:
• Economical, Reusable, General Purpose Stencil Material. Clay coated polyethylene bonded to our ultra-removable/repositionable, light tack adhesive and applied to a heavy backing. This 8.5 mil, semi-rigid plastic conforms easily to curved or irregular surfaces, lightly holds itself in place and is impervious to inks, paints or stains. Stencils easily outlast traditional stencil board by many times. The surface coating prevents runs and smears common with most plastic stencils while the adhesive contact produces extremely high quality stencil images. Fully recyclable, safe and non-toxic.